Appleton enhances explosion-proof plug and receptacles
This upgrade targets an important but unmeet need to supply power over long runs to industrial equipment rated at approximately 100-amps. The 150-amp solution eliminates the risk of overdriving, or drawing excessive current beyond the maximum continuous rating on a piece of equipment, that can lead to additional service and maintenance expense.
Other new enhancements include arc-snuffing chambers, multiple grounding styles, and positive polarization to prevent dangerous matching of dissimilar amperages.
The Powertite and EBR are UL Listed, CSA Certified and rated NEMA 4X. They are approved for use in Class 1, Div 1 and 2 hazardous locations, such as petrochemical plants, petroleum refineries, paint and chemical factories, and other areas where ignitable vapors or gases are present.
Appleton is a premium line of hazardous location products under the EGS Electrical Group family of brands. EGS Electrical Group is a worldwide manufacturer of electrical products for virtually every type of environment. Distributors, contractors, engineers, electricians and site maintenance professionals around the world trust EGS brands to make electrical installations safer, more productive and more reliable. EGS is organized into three focused businesses that provide distributors and end-users expert knowledge and excellent service.
American Control Electronics announces DCH403-10 motor control
The DCH403-10 combines a custom regen-capable switching power supply with a low voltage drive to allow control over low voltage motors without the...
Zaber introduces GSM motorized goniometers
Designed to interface with Zaber’s X-MCB1 and X-MCB2 controllers, this device is available in two stackable sizes with 40 and 60 mm centre of...
Phoenix Contact introduces PT 2,5/S-QUATTRO terminal blocks
Up to four 12 AWG conductors can be connected in one feed-through terminal block. The terminal blocks feature Phoenix Contact’s push-in...
Mantracourt announces DSCUSB-PT potentiometer input module
This introduction to Mantracourt’s range of signal converters can be used with resistance based sensors to indicate position, rotation, angle and...
Micro-Epsilon's confocal chromatic controller
Providing a measuring rate of 70kHz, the confocalDT 2471 HS high speed controller is currently the worldwide fastest confocal chromatic controller....
Sensor Concepts chooses Acromag's XCOM-6400 for InfiniSCAN measurement systems
Although the original intent was to use the power management system to reduce processor throughput and keep the board operating under 20 watts per...
Rotork actuators support environmental improvement at Aberthaw Power Station
Through the use of automation that includes Rotork valve actuation, Aberthaw can efficiently generate around 1555 MW of electricity for the...
Dalian Metro uses Rockwell Automation to integrate system, cuts energy usage by 12%
The entire Dalian metro system includes more than 50 redundant Allen-Bradley MicroLogix and CompactLogix controllers with about 100,000 I/O points...
MicroPower Direct releases glossary of power conversion terms
MicroPower Direct's free power conversion glossary contains 19 pages and 800 definitions of terms associated with a range of power technologies and...
Emerson Global Users Exchange 2016
The Emerson Global Users Exchange is more than an industry-leading technical conference…it is a community of manufacturing leaders committed to...