Emerson's wireless network monitors Irish gas transmission pipeline | Automation.com

Emerson's wireless network monitors Irish gas transmission pipeline

Emerson's wireless network monitors Irish gas transmission pipeline
April 27, 2009 - Emerson’s Smart Wireless technology is being used to help monitor an expansive natural gas pipeline transmission system as part of an upgrade to Bord Gáis’ Above Ground Installations in Ireland. New Rosemount wireless devices have replaced aging hard wired devices as part of a trial to decide the future specification of such sites going forward and for other sites that are due upgrades.

Bord Gáis is a leading Irish energy provider, wholly owned by the government of Ireland that is responsible for the supply, transmission and distribution of natural gas to over 600,000 customers. Management of the gas pipeline system is a sophisticated 24-hour operation involving constant monitoring through Supervisory Control and Data Acquisition (SCADA) systems. Gas is transmitted at high pressure, around 60 - 80 bar, from its main facilities and then at remotely located Above Ground Installations (AGIs) it is reduced appropriately to supply regional distribution points and commercial customers. Bord Gáis has in excess of 200 AGIs throughout Ireland, and at all these sites the gas lines in and out are monitored.

Existing AGI’s have between three and twelve pressure transmitters measuring both inlet and outlet pressure. The cooling effect as a result of pressure reduction is also measured using temperature transmitters. These devices are connected, by hardwiring, to an onsite Remote Terminal Unit (RTU) that transmits data back to a SCADA system Master Terminal Unit at the central monitoring station in Cork. Should thresholds be exceeded to pressure or temperature, alarms are activated.

Bord Gáis’ Mains Renewal Programme aims to ensure that the Irish natural gas facility is one of the most modern pipeline systems in Europe. As part of the process, existing AGIs reaching the end of their lifespan are being upgraded with the latest instrumentation. One such site was at Middleton, near Cork, where a number of instruments needed to be upgraded with the latest temperature and pressure transmitters.

When Bord Gáis looked to upgrade the facility with new instrumentation, it was decided to use a network of wireless pressure and temperature transmitters. The Middleton site is quite unusual as it is divided by a road. Although cable ducting was already in place and this could have been reused, this facility presented an excellent application to test wireless technology with a view to installing wireless at other AGI’s.

“Having adopted GPRS (General Packet Radio Service) as a `back up’ communications technology for our RTUs, we were very comfortable with wireless,” said Frank Smiddy, communication & instrumentation engineer, Bord Gáis. “We like to think that we are very forward thinking and open to new ideas and we are always looking to improve our service using the latest technology.”

Whenever new AGI’s are installed to support extensions to the pipeline system, or existing sites are upgraded, Bord Gáis is continually looking to minimize any installation costs. Power and data cabling are usually installed in ducting at the AGI’s. However, burying cables can prove to be costly and time consuming. For the upgrade at Middleton, wireless promised to be lower cost, offered faster installation and start up, and easy integration into the existing RTUs using Modbus serial communications.

Although there is minimal traffic on the road dividing the Middleton facility, Bord Gáis could not use a line of sight wireless solution as the signal may be interrupted by passing cars, affecting the reliability of communications. With Emerson’s self-organizing Smart Wireless technology, each measurement point has a redundant communication to the RTU via two or three routes. Wireless devices can act as a router for other nearby devices, passing messages along until they reach their destination. If there is an obstruction, transmissions are simply re-routed along the network until a clear path to the Smart Wireless Gateway is found. As conditions change or new obstacles are encountered in a plant, such as temporary scaffolding, new equipment, or a parked construction trailer, these wireless networks simply reorganize and find a way to get their signals through.

All of this happens automatically, without any involvement by the user, providing redundant communication paths and better reliability than direct, line-of-sight communications between individual devices and a receiver. This self-organizing technology optimizes data reliability while minimizing power consumption. It also reduces the effort and infrastructure necessary to set up a successful wireless network.

Because cabling enters into potentially explosive zones, regular checks are required of cable integrity as well as the condition of the EX barriers. This is especially important for older sites where there can be an aging cabling infrastructure. Wireless removes such concerns and reduces the number of site inspections needed.

“Emerson’s Smart Wireless technology is ideal for site upgrades where instruments and cabling can be up to 25 years old and in need of replacing,” said Smiddy. “Installing the transmitters is very simple as the wireless devices simply replace the existing analog devices and these then connect back to a gateway that we installed within the existing instrumentation kiosk.”

Bord Gáis was very familiar with Emerson’s Rosemount pressure transmitters and was confident that Emerson’s Smart Wireless technology would work well for this application. Having tested a number of devices on a work bench, they had no hesitation in applying the technology to the Middleton facility.

At Middleton, Rosemount wireless transmitters include five measuring pressure, one differential pressure, and one temperature; all transmitters have been successfully installed and are sending measurements back to the control room via the RTU. The devices are placed in enclosures, standard practice for all instrumentation used at Bord Gáis AGI’s, and the Smart Wireless Gateway is positioned within the instrumentation kiosk, which is effectively a “walk in” enclosure.

“We found that the enclosures do not interfere with the signals at all. We tested a few devices that were positioned furthest away from the gateway and these worked without any problems so we proceeded to install the rest of the transmitters,” explained Brid Sheehan, communication & instrumentation engineer, Bord Gáis. “Reliability of the wireless signal has not been an issue. We trend the wireless transmissions from the control room so we can see if there are any problems, but so far there haven’t been any.”

Emerson's Smart Wireless offering is an extension of the company’s PlantWeb digital architecture that integrates plant and field networks of industrial Wi-Fi and WirelessHART components with wired devices. End users can optimize their wireless network and train personnel using SmartStart wireless services. AMS Suite predictive maintenance software maximizes asset management benefits from wireless. AMS gathers diagnostics from field networks which include Rosemount and Rosemount Analytical wireless devices, wired Micro Motion Coriolis and Daniel flowmeters, and Fisher digital valves. Native wireless interface in the DeltaV or Ovation digital automation systems bring the new process and plant information into full view for operations, maintenance, and plant management.

About Emerson Process Management
Emerson Process Management, an Emerson business, is a leader in helping businesses automate their production, processing and distribution in the chemical, oil and gas, refining, pulp and paper, power, water and wastewater treatment, mining and metals, food and beverage, pharmaceutical and other industries. The company combines superior products and technology with industry-specific engineering, consulting, project management and maintenance services. Its brands include PlantWeb, Fisher, Rosemount, Micro Motion, Daniel, DeltaV , Ovation, and AMS Suite.

About Emerson
Emerson, based in St. Louis, Missouri, USA, is a global leader in bringing technology and engineering together to create innovative solutions for customers through its network power, process management, industrial automation, climate technologies, and appliance and tools businesses. Sales in fiscal 2008 were $24.8 billion.

MORE CASE STUDIES

VIEW ALL

RELATED