Safety Isolators and Splitters provide reliable isolation and signal conversion for HART data in functionally safe process control settings.

SRM Safety Relay Module, a relay repeater module, has been certified by exida for single use in Safety Instrumented Systems up to SIL 2.

WNM provides wireless communications between field sites that are up to 30 miles apart, and can act as a repeater for a virtually unlimited transmission range.

The update allows the NCS to be used as either a single or dual MODBUS master, providing Ethernet and dual MODBUS RTU master/slave communications.

The 2-channel MIT and the 2- and 4-channel MIX miniMOORE products now meet UL 508 criteria—the UL safety standard for industrial control equipment.

Available models supply 350mA or 500mA of isolated, conditioned simplex (non-redundant) or duplex (redundant) power to up to four segments.

STA is certified to IEC 61508: Parts 1, 2 and 3 by TÜV Rheinland for single use in Safety Instrumented Systems up to SIL 2.

miniMOORE family of multi-channel analog signal conditioners provides up to four I/O channels in a 1 inch (25.4 mm) footprint.

The microNCS provides MODBUS RTU master capabilities, distributed data acquisition and control capabilities.

TCS Temperature Concentrator System transmits up to 32 signals on a single twisted wire pair with HART.

A request from a semiconductor manufacturer led to the HTZ, which offers HART Communications and high accuracy for both humidity/dewpoint and temperature measurements.

The rugged I/O system can be used in Class I, Division 2, Groups A, B, C & D Hazardous areas in both the U.S. and Canada. This allows the NCS to be used in locations where explosive gases and liquids may be present.

The TFZ saves wire and installation costs by allowing up to 126 devices to be networked onto one, low cost FOUNDATION fieldbus H1 segment.

The offer includes choice of a thermocouple or RTD, 24 in. of extension wire, and an installation kit with all the necessary mounting components, including a spring, spacers and a clip.

WLM employs Spread Spectrum Frequency Hopping technology and robust error detection and correction for increased wireless security.

In new and retrofit applications, WORM Flexible Sensors replace straight sensor probes with a universal sensor that saves time and money. It fits any thermowell.

The NCS has been running since February 2005 in an environmental chamber at temperatures up to 221°F to prove it will work in Middle Eastern applications.

The EPX2 E/P transmitter is designed for use with normal instrument air, but it can also be used with natural gas, making it possible to use the transmitter in remote locations where no electrical power is available to drive air compressors. Its low power requirement of 3mA@12Vdc allows it to be powered by a battery or solar panel at remote sites.

The BIMETAL Dual-Mode Remote Thermometer provides on-site indication of process temperature conditions, and simultaneously provides a mV or ohm signal proportional to temperature for input to a transmitter, Remote Terminal Unit (RTU), controller, recorder, indicator, PLC, DCS or SCADA system.

The loop-powered Smart HART Temperature and Signal transmitters have input-to-output analog accuracy up to ±0.025°F, the absolute best in the industry. The 4-20mA temperature output signal also has a superimposed HART digital signal, which allows any HART-compatible control device to program zero, span, sensor trim offset and other calibration variables, and to interrogate and read multiple real-time process variables.