September 17, 2014 - Innovative Integration announced FMC-10GE wireless transceiver which provides two 10 Gb Ethernet ports on a custom FMC module. Two standard RJ45 connectors support connection to CAT6e networks providing high speed connectivity to PCs, servers, embedded computers or custom, intelligent IO. Aggregated burst rates of up to 20 Gbps are achievable. The two 10GE ports are fully independent on the module. Monitoring and control signals are mapped to the FMC interface for detection, loss-of-signal, rate and device control.
Atypically, the NIC onboard the FMC-10GE is enumerated and controlled as a PCIe device, under the control of the ePC-K7's quad-core i7 processor rather than the systems Kintex 7 FPGA, allowing use of standard Windows/Linux applications to effectively leverage the communications ports. The FMC-10GE works with legacy Gigabit Ethernet (GbE) switches and Cat 6e cabling.
FEATURES
• Two independent 10GBASE-T interfaces with SR-IOV support • 10 GbE/1 GbE/100 Mb/s copper PHYs integrated on-chip • PCIe 2.1 (2.5GT/s or 5GT/s), Bus width — x1, x2, x4, x8 • Support for jumbo frames of up to 15.5 KB • Flow control support: send/receive pause frames and receive FIFO thresholds • TCP segmentation offload: up to 256 KB • IPv6 support for IP/TCP and IP/UDP receive checksum offload • Fragmented UDP checksum offload for packet reassembly • Message Signaled Interrupts (MSI) • Message Signaled Interrupts (MSI-X) • 128 transmit queues • Receive packet split header • Receive header replication • Dynamic interrupt moderation • Interrupt throttling control to limit maximum interrupt rate and improve CPU usage • DCA support • TCP timer interrupts • No snoop