Van Nuys, Calif. - The AT10-60-01, AT10-60-02 and the AT10-60-03 Motorized Elevator Stages have been released by Optimal Engineering Systems, Inc. (OES).
These compact, low profile elevator stages feature high stability 120 mm x 80 mm (4.724 in. x 3.149 in.) tables and 60 mm +/- 2 mm (2.362 in. +/- 0.078 in.) of vertical travel with a load capacity of 5.0 kg (11.0 lbs).
The scissor lift design combined with precision roller bearings and slide rails assures smooth motion and very high parallelism throughout the raising and lowering of the table. The AT10-60-01 (shown) is driven by a Two-Phase Stepper Motor with micro-stepping capabilities. The repeatability is typically +/- 5 micron and typical positional accuracy is 15 micron. The knob for manual adjustment can be replaced with a Quadrature Incremental Optical Encoder for position verification. The AT10-60-02 is driven by a Three-Phase Brushless Servo Motor with a Quadrature Incremental Optical Encoder for the higher repeatability, positional accuracy and travel speeds typical of a closed loop system.
The AT10-60-03 is driven by a DC Servo Motor with a Quadrature Incremental Optical Encoder. These Z-Axis Stages are ideal for: Microscopy, inspection, metrology, positioning, photonics, sampling and laser drilling and machining. The table of each stage has a pattern of threaded holes for fixtures or tooling, and in the base are accessible countersunk holes allowing easy integration into a new or existing application. These stages require a Motion Controller that can be ordered as a complete plug-and-play system with RS-232, USB, joystick, trackball and keypad control.